Pandora RMD-5M Wiring
 

Hello i need help reinstalling the RMD-5M Can you show me where the wires connect.
http://www.alarmforum.ru/uploadimg/i...bb4234fcbf.png

The orange wire and the green wire where alrady installed before i removed from old vehicle.
http://www.alarmforum.ru/uploadimg/i...cf3a44c74f.png

your car is there and your car alarm system?
left side - car ? right side- rmd5?

you install car alarm system or REinstall?

base setting of system -
RED with fuse - connect to battery power (+)(input)
Orange - connect to ACC(output )
Brown - connect to the ignition 1, which does not disappear at start.( output)
Yellow - starter (output).



check the condition on the ignition switch.)))


if you want to change the state of the outputs, use the app Pandora Specialist for android or app ALARM STUDIA (the app is localized to your country) for WIN-system computer.


If you use the connection


The orange wire and the green wire where alrady installed before i removed from old vehicle.
http://www.alarmforum.ru/uploadimg/i...cf3a44c74f.png

Connect greeen /red connect wire to red ( before protected fuse)

Amarm was removed from my car & i reinstall into the same car but newer. i made notes for all wires wires for the alarm. The notes I took for the RMD-R5 autostart got lost.
the amarm is installed and working correctly.

in alarm studio how do i view the state of outputs for the RMD-5M.

What is name your alarm system?

DLX 1090L

Please sent you question to email : support@pandorainfo.com . And write number phone and whatsupp or slype .

Добавлено через 1 час 39 минут

Connect greeen /red connect wire to red ( AFTER protected fuse)( +bat -> fuse-> green/red +red !!! sorry/

But the reply times from them are slow.
So on the RMD-5M. What is the R1 & R2 used for ?